South Venice sits outside the city limits on the mainland, south of the island, and its lots run larger than anything on the Nolen grid. The housing is mostly single-story ranch stock with a screened pool cage or lanai out back, and a good number of those cages are still on their original screws.
Venice Lanai Screens connects homeowners in South Venice with a local screen contractor who looks at the whole enclosure, not just the torn panel. The aluminum under an old cage is usually fine. What ages out is the mesh, the fasteners, and the finish, and all three can be renewed in one project.
Chalky, faded paint on the frame is a sign of long sun exposure, not a verdict on the structure. A frame repainting and cage restoration job cleans, seals, and recoats the aluminum. Rust streaks under the screw heads say the fasteners were zinc-coated and have been meeting Gulf air for a long while; stainless fastener replacement puts 316 stainless in every connection. Screen that has gone brittle and loose across the board is a lanai and porch rescreening question. The visit sets the scope.
Because South Venice is unincorporated, structural frame work goes through Sarasota County rather than the city. A mesh-only rescreen usually needs no permit. Milton's worst impacts in October 2024 landed in South County, this end of it, and every cage that stood through that wind flexed at its connections. The Venice Area Chamber of Commerce serves businesses on both sides of the city line, and the contractor works both sides too.
Whenever you are ready, call (941) 555-0101 to book a FREE, no obligation written estimate in South Venice.
The makeover: chalked, oxidized aluminum cleaned, prepped, and refinished, with stainless hardware and fresh screen done in the same project. The cage you have, looking like the cage you bought.
Full or partial mesh replacement on aluminum pool enclosures. Walls, roof panels, or the whole cage, with new spline throughout and mesh matched to how the cage faces.
Fresh mesh and spline for under-truss lanais, screened porches, and patio rooms, with door panels and kick plates renewed at the same visit.
Every screw connection in the cage renewed with marine-grade stainless steel. The least visible part of a renovation and the one that matters most when the wind comes back.
Single panels and small sets: torn mesh, blown spline, sagging sections. Mesh matched to the existing weave and color so the repair disappears.
Doors that drag, slam, or will not latch. New mesh, hinges, closers, latches, and kick plates, or a new door hung square when the old one is past adjusting.
A before-June walk-around: cable tension and anchors, fastener condition, spline and mesh, door hardware, with a written punch list you can schedule from.