Nokomis sits between Dona Bay, Shakett Creek, and the Gulf, and the air over its cages carries a little of each. Older trees shade the established streets, and boat ramps put brackish water close to many lanais. Venice Lanai Screens connects homeowners in Nokomis with a local screen contractor.
Homes near Shakett Creek and the bay edges get two things the inland streets do not: damp salt air that reaches the screw heads first, and no-see-ums that breed in the marsh fringe and slip through standard 18/14 mesh. A 20/20 weave stops them, and it is the usual choice for creekside lanai and porch rescreening. Under a mature canopy, leaf litter and sap sit on the roof panels and hold moisture against the frame.
Much of Nokomis was built when cages were assembled with zinc-coated screws, and streaked rust below the heads says the fasteners have been in salt air a long time. Stainless fastener replacement in 316 grade renews every connection once. With new mesh and a repainted frame, that is the makeover: the aluminum underneath is usually fine, and afterward it looks it. Nokomis is unincorporated Sarasota County; a mesh-only rescreen usually needs no permit and structural frame work does.
The Legacy Trail runs north from the 1927 Venice Train Depot through Nokomis, kept up by the volunteers at Friends of the Legacy Trail, and plenty of cages along it have seen a few seasons. A pre-season cage inspection before June catches loose spline and tired screws while the weather is calm.
Call (941) 555-0101 and a contractor will come out to your Nokomis home for a FREE, no obligation written estimate.
The makeover: chalked, oxidized aluminum cleaned, prepped, and refinished, with stainless hardware and fresh screen done in the same project. The cage you have, looking like the cage you bought.
Full or partial mesh replacement on aluminum pool enclosures. Walls, roof panels, or the whole cage, with new spline throughout and mesh matched to how the cage faces.
Fresh mesh and spline for under-truss lanais, screened porches, and patio rooms, with door panels and kick plates renewed at the same visit.
Every screw connection in the cage renewed with marine-grade stainless steel. The least visible part of a renovation and the one that matters most when the wind comes back.
Single panels and small sets: torn mesh, blown spline, sagging sections. Mesh matched to the existing weave and color so the repair disappears.
Doors that drag, slam, or will not latch. New mesh, hinges, closers, latches, and kick plates, or a new door hung square when the old one is past adjusting.
A before-June walk-around: cable tension and anchors, fastener condition, spline and mesh, door hardware, with a written punch list you can schedule from.